Contact – (866) 303-5868

**Please be aware that the submission of the contact form does not constitute legal or form an attorney-client relationship. Trent Cotney, P.A. does not agree to represent you or take your case simply because you complete this form or email the firm. Furthermore, Trent Cotney, P.A. does not wish to represent anyone in a jurisdiction where this website fails to comply with all applicable laws and ethical rules. Do not use the form to submit confidential, privileged, or sensitive information. The information submitted on this form is not privileged. As with any information submitted over the internet, there is a risk that the information could be intercepted, viewed, or retrieved by a third party.

Resources

4 Important Steps to Ladder Safety

Ladders come in a variety of sizes, shapes, and materials. When used correctly, they make jobs easier. When used carelessly, workers are introduced to easily avoidable hazards. This is why keeping ladder safety top of mind is critical.

When in doubt, always check the OSHA website to ensure your roofing crew is in compliance with OSHA ladder requirements. This will reduce the risk of ladder accidents on the job site. In the meantime, following the steps below will keep you on the road to ladder safety.

Choose the Right Ladder

Using the wrong ladder is the leading cause of ladder accidents. Selecting the right ladder for the task is the first step in safety. First, check the weight of the ladder; it should weigh more than the worker and the tools the worker will be carrying. Next, choose the right material. For example, using an aluminum ladder during or near electrical work can be a dangerous hazard. Third, use the right height for each job. Lastly, the type of ladder should be appropriate for the job. If you need to lean against something for support, use an extension ladder.

Inspect All Ladders

Never skimp on ladder inspections. Ladders that are worn with cracked side rails and bent or broken rungs should be replaced. Labels should be legible and components such as latches, rivets, and bolts should be tight and in good condition. If they are worn or rigid, replace them immediately. These issues can be caught if you inspect ladders when you first receive them and after each use. Periodically, have them checked by a ladder inspector.

Set Up Ladders Properly

Ladder injuries also occur due to improper setup. When setting up a ladder, be attentive to the weight of the ladder, what is above you, and how close you are to an entryway. Ladders should also be set up on flat and dry surfaces and easy to see areas. If you must place them in areas that are potential blind spots, make sure the area is properly marked (i.e. cones, signs).

Climb Ladders Properly

To climb a ladder properly, always maintain three points of contact, avoid carrying ladders with tools and equipment, and never tie two ladders together to climb higher heights. Also, it’s important to always face the ladder as you climb and keep the center of your body between the side rails. If you cannot reach something, climb down to reposition the ladder to a closer location.

If you would like to speak with an attorney about OSHA ladder regulations, please contact us at 1-866-303-5868, or submit our contact request form.

Disclaimer: The information contained in this article is for general educational information only. This information does not constitute legal advice, is not intended to constitute legal advice, nor should it be relied upon as legal advice for your specific factual pattern or situation.

Schedule a Consultation Now

Contact Us
Do you know your rights during an OSHA inspection?
Prepare for an OSHA inspection with a free chapter from our book on OSHA defense.
No Thanks
We respect your privacy. Your information is safe and will never be shared.
Don't miss out. Subscribe today.
×
×
WordPress Popup Plugin